Diagnostic Procedure
- CHECK CAN COMMUNICATION LINE
Perform the self-diagnosis. Refer to SELF-DIAGNOSTIC RESULT MODE .
Is a malfunction in the CAN communication indicated in the results?
- YES: Check CAN communication line. Refer to DTC U1000 CAN COMMUNICATION LINE .
- NO: GO TO 2.
- CHECK DTC WITH TCM
With CONSULT-II
- Turn ignition switch "ON". (Do not start engine.)
- Select "ECU INPUT SIGNALS" in "DATA MONITOR" mode for "A/T" with CONSULT-II.
- Depress accelerator pedal and read out the value of "ACCLE POSI" and "THROTTLE POSI".
Check engine speed changes according to throttle position.
- Select "SELF-DIAG RESULTS" mode for "A/T" with CONSULT-II. Refer to SELF-DIAGNOSTIC RESULT MODE .
With GST
Follow the procedure "With CONSULT-II".
OK or NG
- OK: GO TO 4.
- NG: GO TO 3.
- CHECK DTC WITH ECM
With CONSULT-II
- Turn ignition switch "ON". (Do not start engine.)
- Select SELF-DIAG RESULTS" mode for "ENGINE" with CONSULT-II. Refer to CONSULT-II FUNCTION .
With GST
Follow the procedure "With CONSULT-II".
OK or NG
- OK: GO TO 4.
- NG: Check the DTC detected item. Refer to
CONSULT-II FUNCTION
.
- If CAN communication line is detected, go to DTC U1000 CAN COMMUNICATION LINE .
- CHECK DTC
Perform "DTC Confirmation Procedure".
- Refer to DTC CONFIRMATION PROCEDURE .
OK or NG
- OK: INSPECTION END
- NG: Replace the control valve with TCM. Refer to CONTROL VALVE WITH TCM AND A/T FLUID TEMPERATURE SENSOR 2 .