LEMON Manuals: Even more car manuals for everyone

DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.
NOTE: If "DTC Confirmation Procedure" has been previously performed, always turn ignition switch "OFF" and wait at least 10 seconds before performing the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-II 

  1. Turn ignition switch "ON" and select "DATA MONITOR" mode for "A/T" with CONSULT-II.
    Fig 1: Displaying CONSULT-II SELECT SYSTEM Screen
    G02249964Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Start engine and maintain the following conditions for at least 10 consecutive seconds.

    VHCL SPEED SE: 10 km/h (6 MPH) or more 

    ACCELE POSI: More than 1/8 

    Selector lever: "D" position 

  3. If DTC is detected, go to DIAGNOSTIC PROCEDURE .