LEMON Manuals: Even more car manuals for everyone

Removal & Installation: Installation

Install in the reverse order of removal paying attention to the following.

Fig 1: Main Muffler Mounting Bracket Bolt Tightening Sequence
G01176913Courtesy of NISSAN MOTOR CO., U.S.A.
CAUTION:
  • Always replace exhaust tube gaskets with new ones when reassembling.
  • If the heat insulator is badly deformed, repair or replace it. If deposits such as mud pile up on the heat insulator, remove them.
  • When installing the heat insulator avoid large gaps or interference between the heat insulator and each exhaust pipe.
  • Remove deposits from the sealing surface of each connection. Connect them securely to avoid gas leakage.
  • Temporarily tighten mounting nuts on the exhaust manifold side and mounting bolts on the vehicle side. Check each part for unusual interference, and then tighten them to the specified torque.
  • When installing each mounting rubber, avoid twisting or unusual extension in up/down and right/left directions.