Models Without Navigation System
- Turn ignition off. Disconnect sunload sensor connector located at top right of instrument panel. See Figure . Turn ignition on. Measure voltage between sunload sensor harness connector terminal No. 1 (Light Green/Red wire) and ground. If about 5 volts are present, go to next step. If about 5 volts are not present, go to step 4 .
- Turn ignition off. Disconnect A/C auto amplifier harness connector. Check continuity of Green/White wire between A/C auto amplifier harness connector terminal No. 11 and sunload sensor harness connector terminal No. 2. If continuity is present, go to next step. If continuity is not present, repair open in wiring harness or connector as necessary. See WIRING DIAGRAMS .
- Reconnect A/C auto amplifier. Measure input of sunload sensor to A/C auto amplifier. Backprobing, connect voltmeter between A/C auto amplifier connector terminal No. 12 (Light Green/Red wire) and ground. If voltage varies as sunlight is applied to and removed from sensor, replace A/C auto amplifier. Perform self-diagnosis step 2 and ensure code No. 20 is displayed. See SELF-DIAGNOSIS STEP 2 under SELF-DIAGNOSTICS. If voltage does not vary as sunlight is applied to sensor, replace sunload sensor. Perform self-diagnosis step 2 and ensure code No. 20 is displayed. See SELF-DIAGNOSIS STEP 2 under SELF-DIAGNOSTICS.
- Turn ignition off. Disconnect A/C auto amplifier harness connector. Check continuity of Light Green/Red wire between A/C auto amplifier harness connector terminal No. 12 and sunload sensor harness connector terminal No. 1. If continuity is present, replace A/C auto amplifier. Perform self-diagnosis step 2 and ensure code No. 20 is displayed. See SELF-DIAGNOSIS STEP 2 under SELF-DIAGNOSTICS. If continuity is not present, repair wiring harness or connectors as necessary. See WIRING DIAGRAMS .