LEMON Manuals: Even more car manuals for everyone

Models With Navigation System

  1. Turn ignition off. Disconnect sunload sensor connector located at top right of instrument panel. See Figure . Turn ignition on. Measure voltage between sunload sensor harness connector terminal No. 1 (Light Green/Red wire) and ground. If about 5 volts are present, go to next step. If about 5 volts are not present, go to step  4 .
  2. Turn ignition off. Disconnect display/navigation control unit harness connector. Check continuity of Green/White wire between display/navigation control unit harness connector terminal No. 9 and sunload sensor harness connector terminal No. 2. If continuity is present, go to next step. If continuity is not present, repair open in wiring harness or connector as necessary. See WIRING DIAGRAMS  .
  3. Reconnect display/navigation control unit. Measure input of sunload sensor to display/navigation control unit. Backprobing, connect voltmeter between display/navigation control unit connector terminal No. 10 (Light Green/Red wire) and ground. If voltage varies as sunlight is applied to and removed from sensor, replace display/navigation control unit. Perform self-diagnosis step 2 and ensure code No. 20 is displayed. See SELF-DIAGNOSIS STEP 2  under SELF-DIAGNOSTICS. If voltage does not vary as sunlight is applied to sensor, replace sunload sensor. Perform self-diagnosis step 2 and ensure code No. 20 is displayed. See SELF-DIAGNOSIS STEP 2  under SELF-DIAGNOSTICS.
  4. Turn ignition off. Disconnect display/navigation control unit harness connector. Check continuity of Light Green/Red wire between display/navigation control unit harness connector terminal No. 12 and sunload sensor harness connector terminal No. 1. If continuity is present, replace display/navigation control unit. Perform self-diagnosis step 2 and ensure code No. 20 is displayed. See SELF-DIAGNOSIS STEP 2  under SELF-DIAGNOSTICS. If continuity is not present, repair wiring harness or connectors as necessary. See WIRING DIAGRAMS  .