LEMON Manuals: Even more car manuals for everyone

Models With Navigation System

  1. Turn ignition off. Disconnect in-vehicle temperature sensor connector located to right of steering wheel. See Figure . Turn ignition on. Measure voltage between in-vehicle temperature sensor harness connector terminal No. 1 (Pink/Blue wire) and ground. If about 5 volts are present, go to next step. If about 5 volts are not present, go to step  4 .
  2. Turn ignition off. Disconnect display/navigation control unit harness connector. Check continuity of Green/White wire between display/navigation control unit harness connector terminal No. 9 and in-vehicle temperature sensor harness connector terminal No. 2. If continuity is present, go to next step. If continuity is not present, repair wiring harness or connector as necessary. See WIRING DIAGRAMS  .
  3. Check in-vehicle temperature sensor resistance. See AMBIENT TEMPERATURE SENSOR, INTAKE SENSOR & IN-VEHICLE TEMPERATURE SENSOR RESISTANCE  table. If resistances are not to specification, replace in-vehicle temperature sensor. Perform self-diagnosis step 2 and ensure code No. 20 is displayed. See SELF-DIAGNOSIS STEP 2  under SELF-DIAGNOSTICS. If resistances are to specification, replace display/navigation control unit. Perform self-diagnosis step 2 and ensure code No. 20 is displayed. See SELF-DIAGNOSIS STEP 2  under SELF-DIAGNOSTICS.
  4. Disconnect display/navigation control unit harness connector. Check continuity of Pink/Blue wire between display/navigation control unit harness connector terminal No. 3 and in-vehicle temperature sensor harness connector terminal No. 1. If continuity is present, replace display/navigation control unit. Perform self-diagnosis step 2 and ensure code No. 20 is displayed. See SELF-DIAGNOSIS STEP 2  under SELF-DIAGNOSTICS. If continuity is not present, repair wiring harness or connectors as necessary. See WIRING DIAGRAMS  .