LEMON Manuals: Even more car manuals for everyone

Throttle Position (TP) Sensor

  1. Turn ignition off. Disconnect TP sensor harness connector. Using a DVOM, measure resistance between terminals "a" and "b" and between terminals "d" and "e" of sensor. See Fig 1 .
  2. Resistance should be approximately 1000 ohms with throttle closed. As throttle is opened, resistance should gradually increase up to 10,000 ohms with throttle completely open. If sensor does not respond as indicated, loosen TP sensor mounting screws. Adjust TP sensor to obtain correct resistance. If correct resistance cannot be obtained, replace TP sensor.
Fig 1: Testing TP Sensor (G20)
G95F31927Courtesy of NISSAN MOTOR CO., U.S.A.