Description And Operation: Description
The steering angle sensor is applied as follows.
- The C-MDPS is installed inside the MDPS assembly.
- The R-MDPS is separately installed at the bottom of the clock spring.
| NO | SIGNAL |
|---|---|
| 1 | CAN-LOW |
| 2 | CAN-HIGH |
| 3 | 12V (IGN - 1) |
| 4 | GND |
* The R-MDPS resets SAS zero point during steering system maintenance.
- After replacing the steering column, wheel, and clock spring, perform SAS zero calibration.
The SAS is used to determine turning direction and speed of the steering wheel.
The HECU uses the signals from the SAS when performing ESC-related calculations.
Components (Steering Angle Sensor, Torque Sensor, Failsafe relay, etc.) of the MDPS system are located inside the steering column & MDPS unit assembly and the steering column.
CAUTION:
- Steering column & MDPS unit assembly must not be disassemble to be inspected.