LEMON Manuals: Even more car manuals for everyone

Repair Procedures: Installation

  1. To install, reverse the removal procedure.
  2. After installation, bleed the brake system.

    (Refer to ESP (Electronic Stability Program) System - "ESP SYSTEM BLEEDING ")

  3. Connect the diagnostic tool to the data link connector located underneath the dash panel.
  4. Conduct the Variant coding.
  5. Conduct the Auto Detected Sensor Calibration.
  6. Conduct the Longitudinal G Sensor Calibration.
  7. After replacing the ESP control module execute the "Assembly Check (ECU replacement)" of the additional function to check that the mounting is successful.