LEMON Manuals: Even more car manuals for everyone

Component Inspection

  1. IG "OFF" and disconnect Fuel Pump Relay connector.
  2. Measure resistance between battery power supply and power supply to fuel pump motor terminals of fuel pump relay. (Measurement "A")
  3. Measure resistance between battery power supply and fuel pump relay control terminals of fuel pump relay. (Measurement "B")

    Specification

    Terminal Continuity
    Battery power supply - Power supply to Fuel pump motor NO
    Battery power supply - Fuel pump relay control YES (Approx. 70Ω ~ 120Ω)
  4. Is the measured resistance within specification?

    YES 

    • Substitute with a known - good ECM and check for proper operation. If the problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Substitute with a known - good Fuel Pump Relay and check for proper operation. If the problem is corrected, replace Fuel Pump Relay and go to "VERIFICATION OF VEHICLE REPAIR " procedure.