LEMON Manuals: Even more car manuals for everyone

Water Temperature Control Assembly

  1. Disconnect the battery "-" terminal.
  2. Remove the engine under cover.
  3. Loosen the drain plug and drain the engine coolant.

    (Refer to Cooling System - "COOLANT ")

  4. Remove the air cleaner assembly.

    (Refer to "AIR CLEANER ")

  5. Disconnect the radiator upper hose (A) and lower hose (B).
    Fig 1: Identifying Radiator Upper Hose And Lower Hose
    G09267294Courtesy of HYUNDAI MOTOR AMERICA
    NOTE: When installing radiator hoses, install as shown in the illustrations.
    Fig 2: Installing Radiator Hoses
    G09267295Courtesy of HYUNDAI MOTOR AMERICA
  6. Disconnect the WTS & gauge unit connector (A).
    Fig 3: Identifying WTS & Gauge Unit Connector
    G09267296Courtesy of HYUNDAI MOTOR AMERICA
  7. Separate the engine wiring protector mounted on the water temperature control assembly.

    (Refer to ENGINE COOLANT TEMPERATURE SENSOR (ECTS)

    Fig 4: Identifying Water Temperature Control Assembly Engine Wiring
    G09267297Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION: When installing, be sure to install the wiring protector mounting bolts of the original.
    If other bolts (longer or larger) has been installed, this can damage the water temperature control assembly and coolant may be leak.
  8. Disconnect the throttle body coolant hoses (A).
    Fig 5: Identifying Throttle Body Coolant Hoses
    G09267298Courtesy of HYUNDAI MOTOR AMERICA
  9. Disconnect the heater hoses (B).
    Fig 6: Identifying Heater Hoses
    G09267299Courtesy of HYUNDAI MOTOR AMERICA
  10. Remove the water temperature control assembly (A).

    Tightening torque: 

    19.6 ~ 23.5 N.m (2.0 ~ 2.4 kgf.m, 14.5 ~ 17.4 lb-ft)

    Fig 7: Identifying Water Temperature Control Assembly
    G09267300Courtesy of HYUNDAI MOTOR AMERICA
  11. Install in the reverse order of removal.
  12. Fill the radiator with coolant and check for leaks.

    (Refer to Cooling System - "COOLANT ")

    NOTE:
    • Refill engine coolant.
    • Refill radiator and reservoir tank with engine coolant.
    • Bleed air from the cooling system.
      • Start engine and let it run until it warms up. (Until the radiator fan operates 3 or 4 times.)
      • Turn Off the engine. Check the level in the radiator, add coolant if needed. This will allow trapped air to be removed from the cooling system.
      • Put radiator cap on tightly, then run the engine again and check for leaks.
    • Clean the battery posts and cable terminals with sandpaper assemble them, then apply grease to prevent corrosion.