LEMON Manuals: Even more car manuals for everyone

Repair Procedures: Replacement

  1. Remove the front seat track mounting cover (A).

    [Front] 

    Fig 1: Identifying Front Seat Track Mounting Cover
    G09268197Courtesy of HYUNDAI MOTOR AMERICA

    [Rear] 

    Fig 2: Identifying Rear Seat Track Mounting Cover
    G09268198Courtesy of HYUNDAI MOTOR AMERICA
  2. After loosening the mounting bolts, remove the front seat assembly (A).

    Tightening torque: 

    34.3 ~ 53.9 N.m (3.5 ~ 5.5 kgf.m, 25.3 ~ 39.8 lb-ft)

    Fig 3: Identifying Front Seat Assembly And Mounting Bolts
    G09268199Courtesy of HYUNDAI MOTOR AMERICA
  3. Disconnect the airbag connector (A), seat warmer & power seat switch connector (B), front seat belt buckle connector (C).

    [Driver's] 

    Fig 4: Identifying Airbag Connector, Seat Warmer & Power Seat Switch Connector And Front Seat Belt Buckle Connector (Driver's)
    G09268200Courtesy of HYUNDAI MOTOR AMERICA

    [Passenger's] 

    Fig 5: Identifying Airbag Connector, Seat Warmer & Power Seat Switch Connector And Front Seat Belt Buckle Connector (Passenger's)
    G09268201Courtesy of HYUNDAI MOTOR AMERICA
  4. Install in the reverse order of removal.

    Information 

    SEAT MOUNTING BOLT INSTALLATION PROCEDURE

    • Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.
    • Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.
    • Set the seat into the most rearward position. Check the front mounting bolt completely.
    • Check that the seat operates to and fro smoothy and the locking portion locks properly.