LEMON Manuals: Even more car manuals for everyone

Component Inspection

  1. Ignition "OFF".
  2. Ignition "ON" & Engine "OFF".
  3. Connect GDS and select "Diagnostic Trouble Codes (DTCs)" mode.
  4. Using a GDS, Clear DTC.
  5. Select "Diagnostic Trouble Codes (DTCs)" mode again.
  6. Are any DTCs present?
    YES 
    • Substitute with a known-good steering column & EPS unit assembly check for proper operation.

      If problem is corrected, replace steering column & EPS unit assembly and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 
    • Fault is intermittent caused by faulty EPS CM or was repaired and EPS CM memory was not cleared. Go to "VERIFICATION OF VEHICLE REPAIR " procedure.