LEMON Manuals: Even more car manuals for everyone

Monitor GDS Data

  1. Connect GDS to Data Link Connector (DLC)
  2. Ignition "ON" & Engine "ON".
  3. Turn the steering wheel to the left or right.
  4. Monitor the "Steering Wheel Torque" parameters on the "Current Data" With GDS.

    Specification:  Approx. 8 ~ 8 Nm.

    Fig 1: Display - Steering Wheel Torque Parameters On Scantool Screen
    G10249304Courtesy of HYUNDAI MOTOR AMERICA
  5. Whenever steering wheel is turned, is the steering sensor's scantool data changed?
    YES 
    • Fault is intermittent and caused either by poor contact in Torque sensor or wiring harness, or it has been repaired and EPS CM memory is not cleared yet.
    • Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
    NO 
    • Check the status of wiring as the need arises,
    • After erasing the DTC with scantool, check if it is removed.

      If the same DTC happens again, replace it with a new one and then performs a steering angle sensor's calibration.

    • Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.