LEMON Manuals: Even more car manuals for everyone

On-vehicle Inspection

Inspect ignition coil assembly and Perform spark test 

  1. Check for DTCs.
    NOTE: * If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to "DTC INDEX ".
  2. Check if sparks occur.
    1. Remove the engine cover.
    2. Remove the ignition coils.
    3. Using a spark plug socket, remove the spark plugs.
    4. Disconnect the 4 injector connectors.
    5. Ground the spark plug to the engine.
      Fig 1: Grounding Spark Plug To Engine
      G09885723Courtesy of HYUNDAI MOTOR AMERICA
    6. Check if spark occurs while engine is being cranked.
      NOTE: * Do not crank the engine for more then 5 seconds.
  3. If sparks do not occur, perform the following test.
    Fig 2: Vehicle Inspection Flowchart
    G00554141Courtesy of HYUNDAI MOTOR AMERICA
  4. Using a spark plug socket, install the spark plugs.
  5. Install the ignition coils.
    NOTE: When inserting ignition coil into the inner side of cylinder head be sure it id fully mated to the spark plug.
  6. Reconnect the ignition coils.
  7. Install the cylinder head center cover and the engine cover.