Component Inspection
- Ignition "OFF".
- Connect "Sport Mode S/W" connector.
- Ignition "ON" & Engine "OFF".
- Measure the voltage between wiring side of "Sport Mode select S/W, Sport Mode up S/W, Sport Mode down S/W" and chassis ground.
- Confirm voltage change when select "+, -".
Specification: 12V (Before select) -> 0V (After select)
- Is "Measured voltage" within specification?
YES
- Fault is intermittent, caused by poor contact in the sensor's and/or PCM/TCM's connector, or was repaired and PCM/TCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Check for open or short in harness. Repair as necessary "Inhibitor switch" and Go to "VERIFICATION OF VEHICLE REPAIR " procedure