LEMON Manuals: Even more car manuals for everyone

Monitor Scantool Data

  1. Connect scantool to Diagnostic Connector.
  2. Ignition "ON" & Engine "OFF".
  3. Monitor the "Engine Speed" parameter on the scan tool.

    Specification:  600±100RPM RPM

    Fig 1: Screen Display - Current Data - Engine RPM At Idle
    G06509506Courtesy of HYUNDAI MOTOR CO.
  4. Is "Engine Speed" output value within specification?

    YES 

    • Fault is intermittent, caused by poor contact in the sensor's and/or TCM (PCM)'s connector, or was repaired and TCM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO