LEMON Manuals: Even more car manuals for everyone

Monitor GDS Data

  1. Connect GDS to Data Link Connector (DLC).
  2. Ignition "ON".
  3. Select "DTC" button, and then Press "DTC Status" to check DTC's information from the DTCs menu.
  4. Read "DTC Status" parameter.
    Fig 1: Scantool Display - DTC Status Parameter
    G00520227Courtesy of HYUNDAI MOTOR CO.
  5. Is parameter displayed "Present fault"?

    YES 

    NO 

    • Fault is intermittent, caused by ECM memory was not cleared after repair. Erase DTC, drive the vehicle to satisfy the "Enable Conditions" shown in DTC DETECTING CONDITION CHART, and then go to "SYSTEM INSPECTION " procedure.