Component Inspection
- Check IATS resistance
- Ignition "OFF" and disconnect IATS connector.
- Measure resistance between signal and ground terminals of IATS connector after checking out the temperature of IATS with GDS (Component Side)
Specification:
TEMPERATURE AND RESISTANCE CHARTTemp. (°C) Resistance (kΩ) -40 (-40°F) 95.95 ~ 105.78 -20 (-4°F) 27.4 ~ 29.77 0 (32°F) 9.08 ~ 9.72 10 (50°F) 5.49 ~ 5.83 20 (68°F) 3.42 ~ 3.61 40 (104°F) 1.43 ~ 1.5 60 (140°F) 0.66 ~ 0.69 80 (176°F) 0.33 ~ 0.34 - Is the measured resistance within specification?
YES
- Substitute with a known-good ECM and check for proper operation. If the problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.NOTE: There is a memory reset function on GDS that can erase optional parts automatically detected and memorized by ECM. Before or after testing ECM on the vehicle, use this function to reuse the ECM on the others
NO
- Substitute with a known-good IATS and check for proper operation. If the problem is corrected, replace IATS and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Substitute with a known-good ECM and check for proper operation. If the problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.