Monitor GDS Data
- Connect GDS to Data Link Connector (DLC).
- Ignition "ON".
- Select "DTC" button, and then Press "DTC Status" to check DTC's information from the DTCs menu.
- Read "DTC Status" parameter.
- Is parameter displayed "Present fault"?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Fault is intermittent, caused by ECM memory was not cleared after repair. Erase DTC, drive the vehicle to satisfy the "Enable Conditions" shown in DTC DETECTING CONDITION CHART, and then go to "COMPONENT INSPECTION " procedure.