Serial Communication Circuit Inspection
- Check short in serial communication line
- "IG KEY OFF"
- Disconnect Smart Key Module connector and ECM connector.
- Measure resistance between serial communication signal terminal of ECM harness connector and chassis ground.
Specification: Infinite (∞)
- Is the measured resistance within specification?
YES
- Go to "Check open in harness " procedure.
NO
- Check for short to ground in harness, repair or replace as necessary, and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Check open in harness
- IG KEY OFF.
- Disconnect Smart Key Module connector and ECM connector.
- Measure resistance between serial communication signal terminal of ECM harness connector and chassis ground.
Specification: About below 1Ω
- Is the measured resistance within specification?
YES
- Check for poor connection between harness connector and Smart Key Module or ECM
Thoroughly check connector for looseness, poor connection, bending, corrosion, contamination, deformation, or damage. Repair or replace as necessary, and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Check for open in signal harness, repair or replace as necessary, and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Check for poor connection between harness connector and Smart Key Module or ECM