DTC U0126: Lost Communication With Steering Angle Sensor Module: Can
- Check short of CAN communication line.
- Ignition Key OFF.
- Connect TCM, ECM, CLUSTER connector.
- Measure voltage between TCM CAN HIGH and CAN LOW terminal.
Specification: Approx. 2.3V
- Is measured voltage within specifications?
YES
- Go to next procedure.
NO
- Repair shorted circuit in CAN communication line as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Check open in CAN communication line
- Ignition Key OFF.
- Disconnect TCM, ECM and CLUSTER connector.
- Measure resistance between TCM CAN HIGH or CAN LOW and CLUSTER CAN HIGH or CAN LOW terminal.
Specification: Approx. 0Ω
- Is measured resistance within specifications?
YES
- Substitute with a known-good EPS ECU and check for proper operation. If the problem is corrected, replace EPS ECU as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Substitute with a known-good Mechatronik (E-module + Valve-body) and check for proper operation. If the problem is corrected, replace Mechatronik (E-module + Valve-body) as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Check open in EPS circuit Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.