LEMON Manuals: Even more car manuals for everyone

Monitor Scantool Data

  1. Connect scan tool to data link connector (DLC), Ignition "ON"
  2. Erase DTC and Engine "ON"
  3. Monitor the "Sport Mode, Sport Mode up-S/W, Sport Mode down-S/W" parameter on the scan tool.
  4. Select "D" range and Drive vehicle, confirm output data.
    Fig 1: Screen Display - Current Data - Sport Mode 1
    G06509743Courtesy of HYUNDAI MOTOR CO.
    Fig 2: Screen Display - Current Data - Sport Mode 2
    G06509744Courtesy of HYUNDAI MOTOR CO.
  5. Is "Sport Mode" operation normally?

    YES 

    • Fault is intermittent, caused by poor contact in the sensor's and/or PCM/TCM's connector, or was repaired and PCM/TCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure

    NO