LEMON Manuals: Even more car manuals for everyone

Monitor Scantool Data

  1. Connect scan tool to data link connector (DLC), Ignition "ON"
  2. Erase DTC and Engine "ON"
  3. Monitor the "Battery voltage" parameter on the scan tool.
  4. Confirm the Battery voltage in Idle status.

    Specification:  13.5 ~ 14.5V

    Fig 1: Screen Display - Current Data - Battery Voltage In Idle Status
    G06509720Courtesy of HYUNDAI MOTOR CO.
  5. Is "Battery voltage" within specification?

    YES 

    • Fault is intermittent, caused by poor contact in the sensor's and/or PCM/TCM's connector, or was repaired and PCM/TCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure

    NO