LEMON Manuals: Even more car manuals for everyone

Monitor Scantool Data

  1. Connect scantool to data link connector (DLC).
  2. Engine "ON".
  3. Monitor the "OUTPUT SPEED SENSOR" parameter on the scan tool.
  4. Drive the vehicle.
    Fig 1: Screen Display - Current Data - Input Speed Sensor Signal While Driving
    G06509566Courtesy of HYUNDAI MOTOR CO.
  5. Is "Output speed sensor" output value within normal range?

    YES 

    • Fault is intermittent, caused by poor contact in the sensor's and/or PCM/TCM's connector, or was repaired and PCM/TCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO