LEMON Manuals: Even more car manuals for everyone

Monitor Scantool Data

  1. Connect scantool to data link connector (DLC).
  2. Ignition "ON" & Engine "OFF".
  3. Monitor the "Inhibitor S/W" parameter on the scantool.
  4. Move selector lever from "P" range to "D" range.
    Fig 1: Screen Display - Current Data - Working Status Of Inhibitor S/W
    G06509539Courtesy of HYUNDAI MOTOR CO.
  5. Does "Inhibitor S/W" follow the reference data?

    YES 

    • Fault is intermittent, caused by poor contact in the sensor's and/or TCM (PCM)'s connector, or was repaired and TCM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO