LEMON Manuals: Even more car manuals for everyone

Repair Procedures: Disassembly

  1. Drain the ATF by removing the drain plug and retighten the drain plug.
  2. Remove the plastic oil pan (A) by removing the special bolts (20ea) with TORX wrench (T40).
    CAUTION: Be careful not to drop or damage the plastic oil pan.
    Fig 1: Identifying Plastic Oil Pan
    G06509808Courtesy of HYUNDAI MOTOR CO.
  3. After pulling the white clip (A) upward, remove the connector housing (B).
    Fig 2: Identifying Clip & Connector Housing
    G06509809Courtesy of HYUNDAI MOTOR CO.
  4. Remove the Mechatronik (A) by removing the special bolts (10ea) with TORX wrench (T40).
    CAUTION: Be careful not to drop or damage the Mechatronik.
    Fig 3: Identifying Mechatronik
    G06509810Courtesy of HYUNDAI MOTOR CO.
  5. Remove the adapter (A).
    CAUTION: Must use new ones when reassembled.
    Fig 4: Identifying Adapter
    G06509811Courtesy of HYUNDAI MOTOR CO.
  6. Remove the selector shaft (A), detent disk (B), and connecting rod (C) by removing the holding pin.
    Fig 5: Identifying Selector Shaft, Detent Disk & Connecting Rod
    G06509812Courtesy of HYUNDAI MOTOR CO.
  7. Remove the guide plate (A) by removing the special bolts (10ea) with TORX wrench (T27).
    Fig 6: Identifying Guide Plate
    G06509813Courtesy of HYUNDAI MOTOR CO.
  8. Remove the spring and ratchet (A) by pushing out the guide pin.
    Fig 7: Identifying Spring & Ratchet
    G06509814Courtesy of HYUNDAI MOTOR CO.
  9. Pull out the four oil seal (A).
    CAUTION: Must use new ones when reassembled.
    Fig 8: Identifying Oil Seal
    G06509815Courtesy of HYUNDAI MOTOR CO.