Control Circuit Inspection
- Check signal wave form
- Ignition "OFF" and disconnect Cooling fan relay (low).
- Ignition "ON".
- Measure voltage between Cooling fan relay control (Low) terminal of Cooling fan relay (low) harness connector and chassis ground.
Specification : Changed voltage detected
- Is the measured voltage within specifications?
YES
- Substitute with a known-good ECM and check for proper operation. If the problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.NOTE: There is a memory reset function on GDS that can erase optional parts automatically detected and memorized by ECM. Before or after testing ECM on the vehicle, use this function to reuse the ECM on the others
NO
- Repair open or short in control circuit, and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Substitute with a known-good ECM and check for proper operation. If the problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.