Component Inspection
- Check FLS resistance
- IG "OFF" and Disconnect Fuel Sender & Fuel Pump Motor connector and Fuel Sub Sender connector.
- Remove these senders from fuel tank and measure the resistance of Fuel sender while lifting up and down the fuel level float.
- Does the resistance of FLS change as lifting up and down the fuel level float?
YES
- Substitute with a known - good ECM and check for proper operation. If the problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known - good Fuel Sender or Fuel Sub Sender and check for proper operation. If the problem is corrected, replace Fuel Sender or Fuel Sub Sender and go to "VERIFICATION OF VEHICLE REPAIR " procedure.