LEMON Manuals: Even more car manuals for everyone

Monitor GDS Data

  1. Connect GDS to Data Link Connector (DLC).
  2. Warm up the engine to normal operating temperature.
  3. Monitor the "A/C pressure sensor" parameters on the GDS.
    Fig 1: Normal Data Of A/C Pressure Sensor Without A/C Switch Off
    G07306504Courtesy of HYUNDAI MOTOR CO.
  4. Are the parameters displayed correctly?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO