LEMON Manuals: Even more car manuals for everyone

Power Circuit Inspection

  1. IG "OFF" and disconnect ECM connector
  2. IG "ON"
  3. Measure voltage between memory power terminal of ECM harness connector and chassis ground

    Specification:  Approx. B+

    Fig 1: Measuring Voltage Between Memory Power Terminal Of ECM Harness Connector And Chassis Ground
    G07252478Courtesy of HYUNDAI MOTOR CO.
  4. Is the measured voltage within specification?

    YES 

    • Substitute with a known - good ECM and check for proper operation. If the problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
      NOTE: There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by ECM. Before or after testing ECM on the vehicle, use this function to reuse the ECM on the others

    NO 

    • Check for open or short to ground in harness.
    • Check whether fuse is installed or blown off.
    • Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.