LEMON Manuals: Even more car manuals for everyone

Control Circuit Inspection

  1. IG "OFF" and disconnect A/C Relay and ECM connector.
  2. Measure the resistance between control terminal of A/C relay harness connector and chassis ground.

    Specification:  Infinite

    Fig 1: Measuring Resistance Between Control Terminal Of A/C Relay Harness Connector And Chassis Ground
    G07252176Courtesy of HYUNDAI MOTOR CO.
  3. Is the measured resistance within specification?

    YES 

    • Go to "Check open in harness" as follows.

    NO 

  1. IG "OFF" and disconnect A/C relay and ECM connector.
  2. Measure the resistance between control terminal of A/C relay harness connector and A/C relay control terminal of ECM harness connector.

    Specification:  Approx. below 1Ω

    Fig 2: Measuring Resistance Between Control Terminal Of A/C Relay Harness Connector And A/C Relay Control Terminal Of ECM Harness Connector
    G07252177Courtesy of HYUNDAI MOTOR CO.
  3. Is the measured resistance within specification?

    YES 

    NO