LEMON Manuals: Even more car manuals for everyone

Power Circuit Inspection

  1. IG "OFF" and disconnect Cooling fan module connector.
  2. IG "ON".
  3. Measure voltage between power supply terminal of Cooling fan module harness connector and chassis ground.

    Specification: Approx.12V

    Fig 1: Measuring Voltage Between Power Supply Terminal Of Cooling Fan Module Harness Connector And Chassis Ground
    G07252035Courtesy of HYUNDAI MOTOR CO.
    Fig 2: Identifying ECM Connector Terminals
    G07252036Courtesy of HYUNDAI MOTOR CO.
  4. Is the measured voltage within specification?

    YES

    NO

    • Check if cooling fan fusible link 60A is open or not installed.
    • Check if cooling fan relay is not installed or faulty.
    • Check if the line between cooling fan relay and Cooling fan module is open.
    • Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.