LEMON Manuals: Even more car manuals for everyone

Component Inspection

  1. IG "OFF" and disconnect Fuel Pump Relay connector.
  2. Measure resistance between battery power supply and power supply to fuel pump motor terminals of fuel pump relay. (Measurement "A")
  3. Measure resistance between battery power supply and fuel pump relay control terminals of fuel pump relay. (Measurement "B")

    Specification: 

    TERMINALS CONTINUITY CHART

    Terminal Continuity
    Battery power supply - Power supply to Fuel pump motor NO
    Battery power supply - Fuel pump relay control YES(Approx. 70Ω ~ 120Ω)
    Fig 1: Measuring Resistance Between Battery Power Supply And Power Supply To Fuel Pump Motor Terminals Of Fuel Pump Relay (Measurement A)
    G07251550Courtesy of HYUNDAI MOTOR CO.
  4. Is the measured resistance within specification?

    YES 

    • Substitute with a known - good ECM and check for proper operation. If the problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
      NOTE: There is a memory reset function on scantool that can erase optional parts automatically detected and memorized by ECM. Before or after testing ECM on the vehicle, use this function to reuse the ECM on the others

    NO 

    • Substitute with a known - good Fuel Pump Relay and check for proper operation. If the problem is corrected, replace Fuel Pump Relay and go to "VERIFICATION OF VEHICLE REPAIR " procedure.