LEMON Manuals: Even more car manuals for everyone

Signal Circuit Inspection

  1. Check voltgae
    1. IG "OFF" and disconnect TPS connector.
    2. IG "ON" and ENG "OFF"
    3. Measure voltage between terminal 7 of TPS harness connector and chassis ground.

      Specification:  Approx. 5V

      Fig 1: Measuring Voltage Between Terminal 7 Of TPS Harness Connector And Chassis Ground
      G06804463Courtesy of HYUNDAI MOTOR CO.
    4. Is the measured voltage within specification?

      YES 

      • Go to " 3 Check short to battery in harness" as follows.

      NO 

      • Go to " 2 Check open in harness" as follows.
  2. Check open in harness
    1. IG "OFF" and disconnect TPS connector and PCM connector.
    2. Measure resistance between terminal 7 of TPS harness connector and terminal 48 of PCM harness connector.

      Specification:  Below 1Ω

      Fig 2: Measuring Resistance Between Terminal 7 Of TPS Harness Connector And Terminal 48 Of PCM Harness Connector
      G06804464Courtesy of HYUNDAI MOTOR CO.
    3. Is the measured resistance within specification?

      YES 

      NO 

  3. Check short to battery in harness
    1. IG "OFF" and disconnect TPS connector and PCM connector.
    2. Measure resistance between terminals 4 and 7 of TPS harness connector.
    3. Measure resistance between terminals 1 and 7 of TPS harness connector.
    4. Measure resistance between terminals 2 and 7 of TPS harness connector.
    5. Measure resistance between terminals 3 and 7 of TPS harness connector.

      Specification:  Infinite

      Fig 3: Measuring Resistance Between Terminals 1 And 7 Of TPS Harness Connector
      G06804465Courtesy of HYUNDAI MOTOR CO.
    6. Is the measured resistance within specification?

      YES 

      NO