LEMON Manuals: Even more car manuals for everyone

Signal Circuit Inspection

  1. Check voltage
    1. IG "OFF" and disconnect IATS connector.
    2. IG "ON" and ENG "OFF"
    3. Measure voltage between terminal 4 of IATS harness connector and chassis ground.

      Specification:  Approx. 5V

      Fig 1: Measuring Voltage Between Terminal 4 Of IATS Harness Connector And Chassis Ground
      G06804417Courtesy of HYUNDAI MOTOR CO.
    4. Is the measured voltage within specification?

      YES 

      NO 

      • If the voltage is 0V, go to " 3 Check open in harness" as follows. If the voltage is more than 5.1V, go to " 2 Check short to battery in harness" as follows.
  2. Check short to battery in harness
    1. IG "OFF" and disconnect IATS connector and PCM connector.
    2. Measure resistance between terminals 2 and 4 of IATS harness connector.
    3. Measure resistance between terminals 1 and 4 of IATS harness connector.

      Specification:  Infinite

      Fig 2: Measuring Resistance Between Terminals 2 And 4 Of IATS Harness Connector
      G06804418Courtesy of HYUNDAI MOTOR CO.
      Fig 3: Measuring Resistance Between Terminals 1 And 4 Of IATS Harness Connector
      G06804419Courtesy of HYUNDAI MOTOR CO.
    4. Is the measured resistance within specification?

      YES 

      NO 

  3. Check open in harness
    1. IG "OFF" and disconnect IATS connector and PCM connector.
    2. Measure resistance between terminal 4 of IATS harness connector and 44 of PCM harness connector.

      Specification:  below 1Ω

      Fig 4: Measuring Resistance Between Terminal 4 Of IATS Harness Connector And 44 Of PCM Harness Connector
      G06804420Courtesy of HYUNDAI MOTOR CO.
    3. Is the measured resistance within specification?

      YES 

      NO