LEMON Manuals: Even more car manuals for everyone

Control Circuit Inspection

  1. Check short to ground in harness.
    1. IG "OFF" and disconnect HO2S (B1/S1) connector.
    2. Measure resistance between terminal 2 of HO2S (B1/S1) harness connector and chassis ground.

      Specification:  Infinite

      Fig 1: Measuring Resistance Between Terminal 2 Of HO2S (B1/S1) Harness Connector And Chassis Ground
      G06804240Courtesy of HYUNDAI MOTOR CO.
    3. Is the measured resistance within specification?

      YES 

      • Go to HO2S (B1/S1) " 2 Check Open in harness" as follows.

      NO 

  2. Check open in harness
    1. IG "OFF" and disconnect HO2S (B1/S1) and PCM connector.
    2. Measure resistance terminal between terminal 2 of HO2S (B1/S1) harness connector and terminal 70 of PCM harness connector.

      Specification:  Approx. below 1Ω

      Fig 2: Measuring Resistance Between Terminal 2 Of HO2S (B1/S1) Harness Connector And Terminal 70 Of PCM Harness Connector
      G06804241Courtesy of HYUNDAI MOTOR CO.
    3. Is the measured resistance within specification?

      YES 

      NO