LEMON Manuals: Even more car manuals for everyone

Check Resistance Of IATS

  1. IG "OFF" and disconnect IATS connector.
  2. Measure resistance between signal and ground terminals of IATS connector after checking out the temperature of IATS with scantool.

    SPECIFICATION : 

    IATS SPECIFICATION

    Temp. (°C/°F) Resistance (kΩ) Temp. (°C/°F) Resistance (kΩ)
    -40 (-40) 95.95 ~ 105.78 20 (68) 3.42 ~ 3.61
    -20 (-4) 27.4 ~ 29.77 40 (104) 1.43 ~ 1.5
    0 (32) 9.08 ~ 9.72 60 (140) 0.66 ~ 0.69
    10 (50) 5.49 ~ 5.83 80 (176) 0.33 ~ 0.34
  3. Is the measured resistance within specification ?

    YES: 

    • Substitute with a known - good PCM and check for proper operation. If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO: 

    • Substitute with a known - good IATS and check for proper operation. If the problem is corrected, replace IATS and go to "VERIFICATION OF VEHICLE REPAIR " procedure.