LEMON Manuals: Even more car manuals for everyone

Component Inspection

  1. Check MAPS Performance
    1. IG "OFF" and install scantool.
    2. Connect probe to MAPS and TPS to check signal waveform by using oscilloscope function.
    3. ENG "ON" and monitor signal waveform during acceleration and deceleration.

      SPECIFICATION: 

      PRESSURE SPECIFICATIONS

      Pressure (kPa)  20 35 60 95 101.32
      Voltage (V)  0.789 1.382 2.369 3.75 4
      Tolerance (V)  ± 0.045
      Fig 1: Identifying Signal Waveform
      G04884383Courtesy of HYUNDAI MOTOR CO.
    4. Is the measured signal waveform (MAP/TPS Rationality) O.K?

      YES 

      NO 

      • Substitute with a known - good MAPS and check for proper operation. If the problem is corrected, replace MAPS and go to "VERIFICATION OF VEHICLE REPAIR " procedure.