LEMON Manuals: Even more car manuals for everyone

Power Circuit Inspection

  1. Check voltage of power circuit
    1. Key "OFF".
    2. Disconnect FTPS connector.
    3. Key "ON".
    4. Measure the voltage between terminal 1 of FTPS harness connector and chassis ground.

      Specification: Approx. 5V

    5. Is the measured voltage within specification ?

      YES  : --> Go to "SIGNAL CIRCUIT INSPECTION " procedure.

      NO  : --> Go to "Check Open or Short in power circuit inspection" procedure.

  2. Check Open or Short in power circuit inspection
    1. Key "OFF".
    2. Disconnect FTPS harness connector and ECM/PCM harness connector.
    3. Measure the resistance between terminal 1 of FTPS harness connector and terminal 3/C01-2 of ECM/PCM harness connector. (A/T)

      Measure the resistance between terminal 1 of FTPS harness connector and terminal 50/C01 of ECM/PCM harness connector. (M/T)

      Specification: Approx. 1Ω

    4. Is the measured resistance within specification ?

      YES  : --> Go to "COMPONENT INSPECTION " procedure.

      NO  : --> Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.