LEMON Manuals: Even more car manuals for everyone

Battery Test Procedure

  1. Connect the tester to the battery.
    • Red clamp to battery positive (+) terminal.
    • Black clamp to battery negative (-) terminal.
      Fig 1: Connecting Tester To Battery
      G04801386Courtesy of HYUNDAI MOTOR CO.
      CAUTION: Connect clamps securely. If "CHECK CONNECTION" message is displayed on the screen, reconnect clamps securely. 
  2. The tester will ask if the battery is connected "IN A VEHICLE" or "OUT OF A VEHICLE".

    Make your selection by pressing the arrow buttons; then press ENTER.

    Fig 2: Battery Tester Screen Tool Display - In Vehicle Or Out Of Vehicle
    G04801387Courtesy of HYUNDAI MOTOR CO.
  3. Choose either CCA or CCP and press the ENTER button.
    Fig 3: Battery Tester Screen Tool Display - CCA Or CCP And Press ENTER Button
    G04801388Courtesy of HYUNDAI MOTOR CO.
    NOTE:
    • CCA: Cold cranking amps, is an SAE specification for cranking batteries at 0°F (-18°C).
    • CCP: Cold cranking amps, is an SAE specification for Korean manufacturer's for cranking batteries at 0°F (-18°C)
  4. Set the CCA value displayed on the screen to the CCA value marked on the battery label by pressing up and down buttons and press ENTER.
    Fig 4: Battery Tester Screen Tool Display - SET RATING 660 CCA
    G04801389Courtesy of HYUNDAI MOTOR CO.
    NOTE: The battery ratings (CCA) displayed on the tester must be identical to the ratings marked on battery label.
  5. The tester (Micro570) displays battery test results including voltage and battery ratings.

    A relevant action must be given according to the test results by referring to the battery test results as shown in the table below.

    Fig 5: Battery Tester Screen Tool Display - Good Battery
    G04801390Courtesy of HYUNDAI MOTOR CO.
    NOTE: The battery ratings (CCA) displayed on the tester must be identical to the ratings marked on battery label.
  6. To conduct starter test, continuously, press ENTER.
DEFLECTION CHART

BATTERY TEST RESULTS RESULT ON PRINTER
Good battery No action is required
Good recharge Battery is in a good state
Recharge the battery and use
Charge & Retest Battery is not charged properly
=> Charge and test the battery again (Failure to charge the battery fully may read incorrect measurement value)
Replace battery => Replace battery and recheck the charging system. (Improper connection between battery and vehicle cables may cause "REPLACE BATTERY", retest the battery after removing cables and connecting the tester to the battery terminal directly prior to replacing the battery)
Bad cell-replace => Charge and retest the battery. And than, test results may cause "REPLACE BATTERY", replace battery and recheck the charging system
WARNING: Whenever filing a claim for battery, the print out of the battery test results must be attached.