LEMON Manuals: Even more car manuals for everyone

Control Circuit Inspection

  1. Check for open in signal harness.
    1. Ignition "OFF".
    2. Measure resistance from each ignition coil control circuit to ECM.

      Specification: Approx. 0Ω

      Fig 1: Measuring Resistance From Each Ignition Coil Control Circuit To ECM
      G03849548Courtesy of HYUNDAI MOTOR CO.
    3. Is resistance within the specification?

      YES: 

      • Go to step  2.

      NO: 

  2. Check for short to ground in signal harness.
    1. Measure resistance from each ignition coil control circuit to chassis ground

      Specification: Infinite

      Fig 2: Measuring Resistance From Each Ignition Coil Control Circuit To Chassis Ground
      G03849549Courtesy of HYUNDAI MOTOR CO.
    2. Is resistance within the specification?

      YES: 

      • Go to step  3.

      NO: 

  3. Check for short to battery in signal harness.
    1. Disconnect ECM connector.
    2. Ignition "ON" & Engine "OFF".
    3. Measure voltage from each ignition coil control circuit to chassis ground

      Specification: Approx. 0V

      Fig 3: Measuring Voltage From Ignition Coil Control Circuit To Chassis Ground
      G03849550Courtesy of HYUNDAI MOTOR CO.
    4. Is voltage within the specification?

      YES: 

      NO: