LEMON Manuals: Even more car manuals for everyone

Power Supply Circuit Inspection

  1. Ignition "OFF".
  2. Disconnect HO2S connector.
  3. Ignition "ON" & Engine "OFF".
  4. Measure voltage between terminal 3 of the HO2S heater harness connector and chassis ground.

    Specification: Approx. B+

  5. Is voltage within the specification?

    YES: 

    NO: 

    • Check for an open in the power circuit between the main relay and the HO2S.
    • Especially check for "10A Sensor fuse" is installed and not blown.
    • Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.