LEMON Manuals: Even more car manuals for everyone

Component Inspection

  1. Ignition "OFF".
  2. Remove "TRANSAXLE RANGE SWITCH".
  3. Measure the resistance between each terminal of the sensor.

    Specification : approx. 0Ω

    Fig 1: Measuring Resistance Between Sensor Terminals
    G04892042Courtesy of HYUNDAI MOTOR CO.
    Fig 2: Transaxle Range Switch Continuity Chart
    G04892043Courtesy of HYUNDAI MOTOR CO.
  4. Is resistance within specifications?

    YES 

    • Substitute with a known-good PCM and check for proper operation. If the problem is corrected, replace PCM as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO