LEMON Manuals: Even more car manuals for everyone

Monitor SCANTOOL Data

  1. Ignition "ON" & Engine "OFF".
  2. Connect Scan tool and clear the DTCs.
  3. Monitor Current Data for Immobilizer System.
  4. Retry to communication from the vehicle selection menu although once communication is railed.
    Fig 1: Display Screen - Current Data
    G04893353Courtesy of HYUNDAI MOTOR CO.
  5. Is the communication possible between scan tool and Immobilizer system?

    YES 

    Wait for one hour with IG Key On. Be sure that the battery is fully enough to stay for an hour with IG ON. Disconnecting battery or others manipulation can not reduce this time. After connecting the battery the timer starts again for one hour.

    And then, re-perform key teaching procedure TEACHING PROCEDURES 

    Go to "VERIFICATION OF VEHICLE REPAIR " procedure

    NO 

    Fault is intermittent caused by poor contact in the SMARTRA and/or ECM connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

    Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.