LEMON Manuals: Even more car manuals for everyone

Monitor DTC Status

  1. Check DTC Status
    1. Connect scantool to Data Link Connector (DLC).
    2. IG "ON".
    3. Select "Diagnostic Trouble Codes (DTCs)" mode, and then Press F4 (DTAL) to check DTC's information from the DTCs menu
    4. Read "DTC Status" parameter.
      Fig 1: Scantool Display - DTC Status
      G05348943Courtesy of HYUNDAI MOTOR CO.
    5. Is parameter displayed "Present fault"?

      YES 

      NO 

      • Fault is intermittent caused by PCM memory was not cleared after repair. Erase DTC and drive the vehicle to satisfy the enable condition then, go to "SYSTEM INSPECTION " procedure.