LEMON Manuals: Even more car manuals for everyone

Monitor SCANTOOL Data

WARNING: This page is about a different variant/trim than selected.
  1. Connect scantool to data link connector (DLC).
  2. Ignition "ON" & Engine "OFF".
  3. Monitor the "BATTERY VOLTAGE" parameter on the scantool.
    Fig 1: Scantool Display - BATTERY VOLTAGE Parameter
    G05364192
  4. Does "BATTERY VOLTAGE" follow the reference data?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO