LEMON Manuals: Even more car manuals for everyone

Signal Circuit Inspection

  1. Check for open or short to ground in signal circuit
    1. Ignition "ON" & Engine "OFF"
    2. Measure voltage between terminal 2 of the sensor harness connector and chassis ground

      Specification : Approx. 5V

    3. Is voltage within the specification?

      YES 

      • Go to next step as below

      NO 

  2. Check for short to power in signal circuit
    1. Ignition "OFF"
    2. Disconnect ECM connector
    3. Ignition "ON" & Engine "OFF"
    4. Measure voltage between terminal 2 of sensor harness connector and chassis ground

      Specification : Approx. 0V

    5. Is voltage within the specification?

      YES 

      • Go to next step as below

      NO