LEMON Manuals: Even more car manuals for everyone

Component Inspection

  1. Ignition "ON".
  2. Disconnect ESC switch connector.
  3. Press the ESC switch.
  4. Measure resistance between terminal "3, 6" of the ESC switch component connector.

    Specification :

    Approx. below 1Ω - ESC switch is depressed.

    Approx. ∞ Ω - ESC switch is not depressed.

    Fig 1: Measuring Resistance Between ESC Switch Connector Terminals
    G05365017
  5. Is the measured resistance within specifications?

    YES 

    • Fault is intermittent caused by poor connection in ESC switch line or was repaired and HECU memory was not cleared. Go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Substitute with a known-good ESC switch and check for proper operation. If problem is corrected, replace ESC switch and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.