LEMON Manuals: Even more car manuals for everyone

Component Inspection

  1. Engine "ON".
  2. Install Scan tool and monitor the "MASS AIR FLOW" parameter on the Scan tool data list.
  3. Monitor the "MASS AIR FLOW" parameter on the Scan tool.

    Specification: Approx. 10 ~ 20kg/h at idle & No load

  4. Is MAF sensor voltage within the specified value?

    YES: 

    • Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO: 

    • Check MAFS for contamination, deterioration, or damage. Substitute with a known-good MAFS and check for proper operation. If the problem is corrected, replace MAFS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.